well not quite any old iron - what I'm actually after is info on any old motor armature / stators of multi layer variety that I could adapt for my needs, before I go to the expense of having stator plates cut.
ideally it would need to between 16 and 22 cm diameter with between 30 and 40 teeth for winding.
If anyone has a lightbulb moment on an old motor they've seen stripped down that might have seen something useable I'd appreciate a nod. I usually build motors considerably smaller than this so all the usual routes are out the window!
any old iron... (Q for motor pro's)
-
- Posts: 43
- Joined: Fri Feb 01, 2008 4:45 pm
- Location: Southampton
Who is online
Users browsing this forum: No registered users and 37 guests