Well, I've sold my Cagiva Freccia conversion.
It's Ok, it's goind to another BVS member and the funds are going into the next Freccia conversion.
The plan is:-
1990 Freccia C12 http://www.bikepics.com/cagiva/frecciac12/ (revised bodywork over C9)
Agni 'Race' motor.
40 off 40Ah Iron Phosphate Thundersky cells giving 128v nominal.
The controller may be a problem and there really aren't any designed for a low impeadance PM motor that run at over 72 volt.
Freccia Sold!
Freccia Sold!
Paul
http://www.compton.vispa.com/scirocco/
http://www.morini-mania.co.uk
http://www.compton.vispa.com/the_named
http://www.compton.vispa.com/scirocco/
http://www.morini-mania.co.uk
http://www.compton.vispa.com/the_named
You may already have seen this Paul, but just in case – someone on the EVDL reckons that Kelly is bringing out a 144V DC controller in a couple of months
http://www.convertthefuture.com/bbs/viewtopic.php?t=16329&start=0&sid=097efdb9f03af03d627b47cbf4091b04
The same thread also gives one answer to my stupid question:
"One specific reason why you cannot use two controllers in series is
that they will not be switching at the same time. This is where they
would need to be designed for the application. It's a similar issue
to the timing of multiple parallel MOSFETs for current increase. If
the two controllers aren't turning their output stages "on" at the
exact same moment the one that's not on will see full pack voltage."
http://www.convertthefuture.com/bbs/viewtopic.php?t=16329&start=0&sid=097efdb9f03af03d627b47cbf4091b04
The same thread also gives one answer to my stupid question:
"One specific reason why you cannot use two controllers in series is
that they will not be switching at the same time. This is where they
would need to be designed for the application. It's a similar issue
to the timing of multiple parallel MOSFETs for current increase. If
the two controllers aren't turning their output stages "on" at the
exact same moment the one that's not on will see full pack voltage."
I only dip into the EVDL occasionally these days, too much noise!
I've been lokking at Kelly controllers, but I wan't to see some real world experience first. Alltrax had problems with low impeadance motors before doing a re-design (re-program).
You can't run a pair of controllers in series for many reasons, but a simple reason is 'where would you connect the motor?'.
I've been lokking at Kelly controllers, but I wan't to see some real world experience first. Alltrax had problems with low impeadance motors before doing a re-design (re-program).
You can't run a pair of controllers in series for many reasons, but a simple reason is 'where would you connect the motor?'.
Paul
http://www.compton.vispa.com/scirocco/
http://www.morini-mania.co.uk
http://www.compton.vispa.com/the_named
http://www.compton.vispa.com/scirocco/
http://www.morini-mania.co.uk
http://www.compton.vispa.com/the_named
Return to “Electric Motor Bikes”
Who is online
Users browsing this forum: No registered users and 20 guests