any old iron... (Q for motor pro's)

General BVS related area
Delinquent
Posts: 43
Joined: Fri Feb 01, 2008 4:45 pm
Location: Southampton

any old iron... (Q for motor pro's)

Postby Delinquent » Fri Aug 15, 2008 3:19 pm

well not quite any old iron - what I'm actually after is info on any old motor armature / stators of multi layer variety that I could adapt for my needs, before I go to the expense of having stator plates cut.

ideally it would need to between 16 and 22 cm diameter with between 30 and 40 teeth for winding.

If anyone has a lightbulb moment on an old motor they've seen stripped down that might have seen something useable I'd appreciate a nod. I usually build motors considerably smaller than this so all the usual routes are out the window!

Return to “General”

Who is online

Users browsing this forum: No registered users and 10 guests